Digmesa FHKSC Three Pin Flowmeter

Digmesa FHKSC Three-Pin Volumetric Flowmeter

A genuine Digmesa volumetric flowmeter with 5 mm barbed fittings, used to meter water dosing on volumetric espresso machines. NSF approved and built from PBT (fiberglass reinforced) and PVDF for long service life in a wet environment.

SPECIFICATIONS

• Orifice: 1.0 mm
• Flow rate range: 0.033 - 0.40 L/min
• Fittings: 5 mm barbed
• Materials: PBT (fiberglass reinforced), PVDF
• NSF approved
• Digmesa part #: 932-9525-B

INSTALLATION

Best installed by a technician, since the machine needs to be re-calibrated to the new flowmeter's pulse count after replacement. See the factory brochure for full specifications.

PRO TIPS

• If dose volumes drift or a group stops dosing altogether, check this before blaming the dosing board, flowmeters wear out from mineral buildup on the impeller, and a sluggish or stuck impeller reads as an electronic fault when it's really a plumbing one.
• Always match orifice size and pulse rate to the original when substituting a flowmeter, a flowmeter that looks physically identical but has a different pulse-per-liter rating will throw every programmed dose off.